Installation Instructions for TRD’s 3.4-liter V6 Supercharger Kit 1997-2000...
download Removal of Stock Intake Manifold (figure 1) 1. Disconnect the battery ground cable. 2. With tape or a permanent marker, mark the forward edge of the power steering and the air conditioning...
View Article2003 Buick Park Avenue Ultra Drive Belt Idler Pulley Replacement (Lower)...
download 1. Remove the supercharger drive belt. 2. Remove the drive belt idler pulley bolt. 3. Remove the drive belt idler pulley. Installation Procedure 1. Install the drive belt idler pulley. Notice:...
View Article2003 Buick Park Avenue Ultra Water Pump Replacement Removal Procedure
download 1. Drain the engine coolant. 2. Remove the drive belt. 3. Remove the supercharger idler pulley assembly. 4. Remove the water pump pulley bolts. 5. Remove the water pump pulley. 6. Remove the...
View Article2003 Buick Park Avenue Ultra Drive Belt Replacement Removal Procedure
download The supercharged 3800 engine uses two drive belts. The outer belt drives the supercharger. The inner belt drives the generator, power steering pump, coolant pump and air conditioning...
View Article2003 Jaguar S-Type Coolant Expansion Tank Removal
download Vehicles without supercharger 1. NOTE: Cap the vent hose to minimize coolant loss. Detach the coolant expansion tank. ^ Detach the vent hose. ^ Remove the coolant expansion tank retaining...
View Article2002 Ford F 150 Crankshaft Pulley – Supercharged Engines Removal
download Removal 1. Remove the supercharger drive belt. 2. Remove the fan blade, clutch and shroud. 3. Raise the vehicle on a hoist. 4. Remove the nut and position the shield aside. 5. Remove the...
View Article2002 Ford F 150 Cooling Fan – Blade, Clutch and Shroud Removal and Installation
download WARNING: Do not run the engine while the protective components are removed. Failure to follow these instructions may result in personal injury. All vehicles 1. Remove the air cleaner assembly....
View Article2003 Nissan Xterra SE S/C TORQUE SPECIFICATIONS
download TORQUE SPECIFICATIONS Application A/C Compressor Bracket Bolts Upper Vertical Bolt Horizontal Bolts A/C Compressor-To-Bracket Bolts Air Inlet Tube-To-Supercharger Bolts Camshaft Locating Plate...
View ArticleC230CL 1.8 Kompressor Engine Performance Complaint
download Engine vibration, rpm fluctuations at idle, or poor accelerator response along with codes P2020 (P0172), P2046, P201C or P201A may be caused by a tear in the partial load vent hose at the...
View Article
